Basic Troubleshooting
Speed-governing fault or
max. speed reduced
Too low cell Voltage
Speed-governing throttle damage
Spring inside throttle goes stuck or fails
Charge the cell
Go for the distributor for replacement
The cells connecting line becomes loose
.Speed governing throttle damaged
Motor output line becomes loose or damaged
Reconnect it:
Ask the distributor for replacement
Ask a repair store for help
Continuous riding mileage
is not sufficient after
charging.
Low tire pressure
Low battery power or charger fails
.Aging of the cell or damaged
Driving on rough terrain
Great headwind, frequent braking and starting, heavy
load on bike
Inspect tire
Fully charge the cell or replace the
charger
Replace the cell
Adjust route
Adjust bike load,include pedal assist
use
Charger nor properly connected
Fuse inside the cell box fused
Battery packs connecting wire falls off
Inspect connections
Replace the fuse
Weld connecting wires
Fault that you cannot determine; the inside of the
motor, cell, controller, charger, etc. damaged
Please ask the distributor for repair, do not
open these parts by yourself. 0therwise,
warranty will not be provided.