until your hand feeling is comfortable.
Replace the braking pad when braking pads are worn off by more than l mm or the adjusting screw of braking pads are adjusted to the end position or every half a year. when replacing braking pads, press in one of
braking pads using a clean slotted screwdriver to vacate space for taking out the other braking pad. After replacement is complete, it is needed to return the adjusting screw of braking pads to a suitable position (a
position that makes your hand feeling comfortable).
Run-in period: the run-in of disc brake surface needs a certain time. After complete run-in, braking force will increase significantly. The first week in which you use a new disc brake is the run-in period. During run-in
period, do not brake with too great force, otherwise unrecoverable damage will be caused to braking pads and braking body. The correct operation method is to brake slightly during driving, so that there is appropriate
friction kept between braking pads and the disc brake.
(2) Considerations
Do not use lubricating oil around the disc brake and braking pads, as well as the caliper. Do not touch the surface of disc brake and braking pads with hands, otherwise braking performance will be reduced
significantly. You’d better not shower a new brake to prevent a small quantity of lubrication grease in assembling clearance from contaminating braking pads. Oil hydraulic disc brake has strong braking force, you
need to do much exercise at a safe place, so as to adapt to the difference from a common brake to avoid braking with too great force, resulting in injury due to wheel lockup.
Operation method of the charger and considerations
(
l) Operation method
①
when charging, plug in the plug of cell box first, then that of electric supply ACl00V-230V. when charging is complete, take the counter procedures, that is, unplug the plug of electric supply ACl00V-230V, then that
of cell box.
②
During normal charging, the indicator light of the charger shows red. when fully charged, it will show green;
③
If charging ambient temperature is too high, the red light will flash, which indicates that the charger is in the temperature protection state. Please take the charger to a cool or well-ventilated place. when the inside
temperature of the charge lowers to 60
℃
, normal charging occurs.
(2) Considerations
1 The charger can only be used indoors.
2 Charging in a closed space or under scorching sun or at a high temperature environment is strictly prohibited. Do not put the charger on a seat cask or inside the rear compartment for charging.
3 In case of no charging, do not connect the charger to an AC power supply without load for a long time. During charging, if the indicator light is abnormal, there is abnormal smell or the housing of the charger is too
hot, please stop charging immediately, and repair or replace the charger.
4 Do not disassemble or replace the devices inside the charger by yourself.
5 Do not charge the charger that has been fully charged.
6 Do not use the charger in an environment with flammable gas, otherwise explosion or fire will be caused.
7 Do not place the charger near water source or wet it, otherwise fire or electric shock may occur.
8 In the event that inside parts are exposed due to charger damage caused by collision, etc., do not touch them with hands, otherwise you may be injured due to electric shock.
(3) Charging
1 Make sure to charge using the charger specifically equipped by our company. Irregular or non-conforming chargers may reduce life the cell or invalid the cell!
To Next Page
Loading...
