2- Maintenance of the running gear :
Maintenance work on the running gear must be performed by qualified and
competent staff with the appropriate tools and a specialised workshop
approved by the vehicle manufacturer.
General inspection
For : ½ tandem, tandem rods
Check and tighten all the nuts on the axle fixation flanges and the draw rods if
present. (follow the order of Diagram 2)
Grease the various pivot pins and the end of the springs in their slide (Figure 1).
Plan 1 Plan 2
Case of the rocker axle or Rollfast
Check the absence of play in the axis of the rocker bar.
Lubricate the various points (14 per axis of the rocker bar or Rollfast)
To Next Page
Loading...