3- Cleaning and lubricating :
Clean the body with copious amounts of water after each transport of corrosive or
soiled goods. After washing, follow up with a general lubrication (oil spray) and verify
the brake functions. For all cleaning and lubrication operations, the machine should
be shut down (see §1-1 of page 3)
Every 10 hours:
-Grease the bed chain drive front and rear
- Greasing of the PTO drive shaft
Every 50 hours:
-Grease the axle, the drawbar and the drive shaft bearings
1 to 3 times/year (depending on use intensity) :
- Grease the beater bearings (to the right of the TCE, at the top of the verticals
(in the upper casing)) Provide adequate means of access (see page 32)
-Grease the drive shaft bearings
The grease points are represented by red dots on the diagram below. The oil of the
various mechanical boxes (gearboxes, gearbox and bevel) should be replaced every
year or every 200 hours in accordance with the amounts shown in the "maintenance
of mechanical boxes." The recommended oil is SAE 140.
To Next Page
Loading...