> Motion-detect recording loop coverage: when the TF Card is fully loaded, will delete the former videos or
photos automatically one by one to acquire relevant space to store new videos. If the function is closed, the
camera will power off automatically when the storage space is fully loaded.
> Lasting time of video recording and motion-detect recording loop coverage function can be amended by the
system settings, please refer to the system setup instruction.
Note:
1、When not used underwater, please open the waterproof plug for better audio recording quality.
2、When the TF Card is full (the loop coverage function closed) or battery used up, the unit will shut down
automatically.
3、Enter into this mode, if you don’t operate the unit for 3 minutes,, LED light will turn off, the camera is still at
work, press any key to instruct.
6. Motion-detect photo taking
> When the camera captures mobile objects, it will take a photo automatically.
> Motion-detect photo taking loop coverage: when the TF Card is fully loaded, it will delete the former videos or
photos automatically one by one to acquire relevant space to store new videos. If the function is closed, the
camera will power off automatically when the storage space is fully loaded.
Note:
1. When the Memory Card is full (the loop coverage function closed) or battery used up, it will shut down
automatically.
2. Enter into this mode, if you don’t operate the unit for 3 minutes, LED light will turn off, the camera is
still at work, press any key to instruct.
7. Turn on the led light
The camera provides 8 bright white LED lights. Please turn on it as below:
Short press" LED light key
" in the state of any mode (except TV-out playback mode), the LED light will circle
in 3 modes;
Mode1: Turn on the 8 white LED lights, you can record your videos in color even in totally darkness.
Mode2: Turn on 4 LED white lights, Brightness abates and it can reduce power consumption.
Mode3: Turn off all the white LED lights.
Note: Press and hold down the led light " " to turn off all the led functions. The camera will shake when it is
operated successfully.
8. Turn off and automatic turn off
In the standby mode, press and hold down the "power key" for two seconds, the blue light flashes 3 times and
goes out, and then release your hand. At the mean time the camera shakes for twice, and then turns off the camera.
Note: The camera will turn off automatically when the TF Card is fully loaded( the loop coverage function
closed)、the battery is used up, the AV cable is disconnected, or there is no operation after 3 minutes, the red&blue
light will flashing alternately when you turn off the camera.
9. Down load a video and removable disk.
> Please turn off the camera first, and then connect it with computer.
To Next Page
Loading...
Need help?
General
