Rollei Rolleiflex T User Manual

but
permit
eye-level focusing by a
mirror
in the hood. To
use this
mirror,
pull
back the
lever
at the side of
the hood.
The built-in
magnifier of
Rolleiflex
2.8D
and
2.8C
is
adjustable
to
correct
for
faulty
eyesight.
Swing the
magnifier outwards until
the
lines
on
the
ground glass
screen
can be clearly
seen.
5. Release the
shutter
gently
by
pressing
the
release button. The
release
of the
Rolleiflex
2.8D, 2.8C
and
later Automats 3.5 has
a
safety
catch which can be
locked.
Special Controls
TIME EXPOSURES
are
made
with
the shutter
set to
B.
On
depres-
sing
the release, the shutter
will remain open
until the
pressure
on the
release is removed.
For long
time
exposures
use a cable release; this
screws
into the centre of the
release button
(or
into a socket on
the
camera
front, in the case of the earliest
models).
FLASH SYNCHRONIZATION.
Rolleiflex models
2.8D, 2.8C
and
later Rolleiflex Automats
are XM-synchronized.
For X-
synchronization, set
the
synchronizing
lever
(next
to
the
flash socket
or-on the
2.8C-between
the
lenses) to X,
for M-synchronization to
M.
On the
model
2.8D
the
lever is next to
the finder
lens. Earlier
Rolleiflex
Automats have
no
setting
lever and
are
permanently
X-
synchronized;
the
first models are
not
synchronized
at
all.
While all synchronized
cameras
will accept the standard
3
mm.
co-axial
plug,
a
special
Rolleiflex
flash
plug
is designed for the later
models with a lead to connect
to the
flash
socket
on the base of
the
camera
front. This
plug
locks
into
position
and can only
be removed
on
pressing
the
lever surrounding
the flash socket.
A
DELAYED
ACTION RELEASE
(selfrtimer)
is
built
into Rollei-
flex
Automat
and is automatically
tensioned on
advancing the film.
It is
thus always
ready for use.
To
bring
it into action,
push
the delayed
action
release button on
top of the
camera front
in
the
direction
of
the
arrow.
After
a delay
of
about
10
seconds,
it will then automatically
release
the shutter.
With the
2.8C and
D,
the self-timer
is worked
by a lever on the
top
right of
the
front
panel.
This
lever is not
linked with the film transport
and
must be tensioned
separately before
use
(move
in the
direction
of
arrow
marked
"V"
on
model2.8D).
DELIBERATE
DOUBLE
EXPOSURES
are
possible
with the
2.8C, 2.8D and the
last 3.5
models. The control
is
a
milled
segment
below the
film
crank.
To
tension
the shutter a second
time
(after
an
exposure)
without advancing
the film,
push
this segment
in the direction
of
the arrow
and turn
the crank
backwards through one
revolution
t
3f AUTOMAT, C,
D

Rollei Rolleiflex T Specifications

General

Brand	Rollei
Model	Rolleiflex T
Category	Digital Camera
Language	English