RolliMini BL100 - Maintenance; Cleaning Side Brushes; Cleaning Dust Bin and Filter

Maintenance
1. Cleaning side
brushes
A.
Check
side brushes
to see
whether they are damaged
or
whethere there are
foreign objects
stuck
on the
brushes.
B.
Clean the side brushes
by tool or
cloth.
C.
Replace
the side brushes
if it's damaged.
Make sure L side brush
at
L
place
and
R side brush
at R
place
on the bottom,
then
push
to lock rnplace.
(Carefully
pull
brush to
remove)
2.
Gleaning dust
bin and
filter
Empty dust bin after each
use, the
procedures
are
shown in figures
below.
A. Press
"PUSH"
mark to open
the robot upper
cover
B. Take out the dust bin by
its handle.
C. Separate
HEPA filter first
from dust bin.
D.
Open
dust
bin
cover and
take out
primary
filter.
E. Empty the dust bin.
F. Wash dust bin and
primary
filter under
tap water,
clean HEPA
with the cleaning
brush.
G.
Install
primary
filter and
HEPA filter
into dust bin after
it is dry, close
dust bin
cover, and
then
install it into the robot.
Note:
o
After taking out dust bin,
check
whether there are
foreign objects
stuck
in dust
passage
and
clean
it.
o
Rinse
HEPA filter after
15-30
days
use.
lt is recommend to
replace
the HEPA
filter after 6-8
months.
o
After rinsing HEPA and
primary
filter,
dry them in a ventilated
& cool
area for optimum
resutls.
and
install
them
after they
are fully dry.
Do not dry filters under
the
sun.
o
HEPA and
primary
filter are both
replaceable.
-il
.iv
..e
\c+
A
B
D
E
F
G 13