Rollplay W421E - Operating Features; Power and Shifter Controls; Pedal and Sound Features; Speed and Lighting Controls

1. Assemble the Steering Rod
(1). Place the vehicle upside down on a soft surface and locate the steering
rod hole.

rod hole.
(3). Insert the screw (24) though the hole located on the shorter end of the

end of the screw.
2. Assemble the Shock Absorbers



(3). Insert the screw (19) through the holes. Then slide the washer and screw
nut onto the screw.
(4). Fasten with a screwdriver and wrench.

3. Assemble the Front Wheels




use the hex wrench (15) to tighten.

on the wheel and press until it clicks into place.
(5). Repeat these steps for the other front wheel.
Helpful Tip:

side marked with an "F" faces inwards.
4. Assemble the Rear Wheels

Slide the rear wheel (7) onto the axle. Ensure that the gears on the wheel



tighten.

on the wheel.
(5). Repeat these steps for the other rear wheel.
Helpful Tip:


2. Remove a wheel from the axle. Pull or push on the axle to slide it until you

5. Assemble the Exhaust Stack
(1). Place the square piece of the exhaust stack in the square slot on the car

6. Assemble the Steering Wheel

(27).

rod.
(3). Align the holes on the steering wheel (3) with the holes on the steering
rod.

steering rod. Insert the nut (17) into the other side of the steering wheel (3).

7. Assemble the Brush Guard


   



8. Attach the Seat
(1). Make sure the seat lock is turned to the unlocked position.



(3). Turn the seat lock clockwise until it is in the locked position to properly

9. Steering Wheel Batteries



           
screwdriver.
10. Product Features
Power Button
           
Light will turn on when the car is on.
Shifter
Pull the Shifter up to move forward. Pull the Shifter down to reverse.
Foot Pedal
Press the Foot Pedal down to move. The vehicle will stop when the Foot
Pedal is released.
Sound Buttons
Press the Sound Buttons on the steering wheel for horn and engine sounds.
High Speed Lock Out

           

to control the speed.




in reverse.
Headlights
The Headlights will turn on automatically when the vehicle is in motion.
Assembly instructions
OPERATING INSTRUCTION
MAINTENANCE
1. Before assembly please check that you have all the parts, if there are any
missing parts please contact your local store.
2. Once assembled please inspect all the parts and ensure the vehicle is
working properly.
3. Please carefully clean the product occasionally and do not destroy any parts.
4. In order to keep your child safe, please inspect and maintain the vehicle
periodically.
CARE