23
2. Removing the blender jug
• Before disassembling the appliance, make sure it is switched off. To do so, turn the rotary knob to the
left to position „0“ and disconnect the power plug.
• Screw the blender jug off once the blades of the blade unit stand still.
Screw the blender jug off by
screwing the blade unit
anticlockwise.
Attention! Don´t screw the
blender jug itself as it may
loosen from the blade unit.
Remove the blender jug from the
base unit when the white mark
of the blade unit is located above
the arrow-mark of the base unit.
Turn the blender jug so that the
blade unit is at the top. Screw off
the blade unit anticlockwise.
Pay attention to dripping liquids
when removing the blade unit.
Place the lid on the blender jug
and screw it tightly in clockwise
direction. Press the lid of the
drinking cap firmly.
Observe the correct position of
the gasket in the lid.
MX200_MX250 - 06_2016_print.indd 23 17.06.2016 08:36:40
To Next Page
Loading...
