24
Using the glass jug
1. Preparing for operation and assembly
• Before assembling the appliance, make sure it is switched off. To do so, turn the rotary knob to the left
to position „0“ and disconnect the power plug.
Place the glass jug on the blade
unit. Observe the correct position
of the gasket in the blade unit!
Screw the blade unit anticlockwi-
se onto the glass jug.
Fill the prepared food into the
glass jug. Observe the maximum
filling quantity!
Place the lid and press it on tightly.
Place the small lid and lock it by
turning it clockwise.
Place the filled glass jug on the
base unit. The white mark of the
blade unit is located above the
arrow-mark of the base unit.
Screw the blade unit clockwise
until the jug snaps into place.
The embossed arrows of the
blade and base unit must be
vertically aligned.
• Before connecting to the mains make sure that the rotary knob is in position “0”.
• Connect the appliance to the mains. Now it is in standby mode, shown by a permanently lit pilot lamp.
• Start the appliance in the desired level.
MX200_MX250 - 06_2016_print.indd 24 17.06.2016 08:36:40
To Next Page
Loading...
