3
Tilt head of Mood Lamp to select a light mode. You can either leave the lamp head tilted, or you
can return it to the neutral position to stay in a particular mode. In any light mode, if you
tilt the head left it will turn off the lights and put the lamp back into the default
Musical Mood mode (see below for more information about Musical Mood).
When a light mode listed below has beat detection (it senses your
music and plays animations to the beat), you will see this icon.
When a light mode listed below doesn’t have beat detection,
you will see this icon.
This is the default mode when the head is in neutral position or has
been tilted left.
You can create your own melodies in this mode by touching sensors
on the lamp head. Use one finger to tap out single notes or drag your
fingers across the head to create melodies. While you are creating your
melodies, the beat detection function will be temporarily disabled. Once
you stop touching the lamp, it will be able to pick up the beat of your
music again and will play an LED light show to your music.
4 LIGHT MODES
BEAT
Musical
Mood
BEAT
BEAT
Pop quiz: See what happens when you hold your hand down on the lamp head for several seconds…
To Next Page
Loading...