ENG
MAINTENANCE
10
when it becomes dirty
when suction is weaker than normal
Attention
Please turn off the vacuum and take off
the floor brush before cleaning it.
Clean the Turbo Brush
Open the lock button
1
Take out the beater bar
2
Clear the blockage inside
3
Use a coin to turn the dial to (unlock) position,
and then pull out the cover piece.
●
Cut off all tangled hair/strings on the beater
bar, and also remove all other debris.
●
Make sure to clear the inside of the
Turbo Brush. If there is blockage in
this area, it will reduce suction power
and possibly trigger the auto-
protect mechanism.
●
→ If the beater bar is strangled too tight and does
not turn anymore, please see Troubleshooting.
→ For more information regarding
auto-protect mechanism, please
see Troubleshooting.
To Next Page
Loading...