- 10 -
Holding the bed face panel in the
down position, place the innersping
mattess on the bed and secure with
elastic retaining straps.
NOTE:When lowering the bed without
the counter balance of the mattress it
may seem very difficult...do not be
concerned, once the mattress is
placed on the bed it will function
easily.
If the mattress is lightwight and the bed
has a tendency to float off the floor,simply
add some weight-i.e.-a piece of particle
board, wood, etc. inside the bed frame at
the end of the bed to counter-balance.
Step 17:
Close bed. If the gap around the bed is
uneven, push or gently kick the base
of the cabinet on the side with the
narrowest gap until desired gap is
obtained.
Step 18:
Close bed. Apply base molding (if applicable) from
oustide of vertical to outside of vertical.
Step 19:
Narrowest Gap
To Next Page
Loading...
