11
Jet E 130 / 170
MACHINE OPERATION
Ÿ Switch on the machine
Ÿ Connect the fresh water supply to
the filter.
E n s u r e t h a t t h e i n f e e d w a t e r i s c l e a n .
DO NOT USE HOT WATER
Ensure to bleed the residual air before starting the
machine. Release the safety lock and press the trigger to
bleed the air.
Ÿ Connect the cable to main power.
Ÿ The machine should only
be connected to a mains power supply equipped with an
adequate earth connection.
Ÿ Release the safety lock and pull
the lever.
After the operation hold the safety lock in trigger for
safety.
Ÿ Adjust the pressure adjustment
knob for your usage
End of cleaning
For Solution
Ÿ Switch OFF the mains power.
Ÿ Stop the water supply for filter inlet.
Ÿ Bleed the residual air from the system by pressing the trigger
for a few seconds.
Ÿ Mount the gun & hose on its place.
Ÿ Clean the filter.
Ÿ Connect the solution tank to the
solution inlet through the hose.
Ÿ Adjust the solution control knob for
usage.
There is a provision to use detergent for cleaning purpose
Ÿ For solution applying, just pull the
nozzle forward.
To Next Page
Loading...