16
RootsScrub B45 Series
PROCEDURE FOR SCRUBBING
At the end of cleaning
Ÿ Stop the machine and lift the brush head.
Ÿ Lift the squeegee.
Ÿ Drain and rinse the dirty water tank (refer to section
"Dirty and Fresh Water Tanks" )
Ÿ Clean the sealing strips at the squeegee.
The machine must not be cleaned by water jet or high
pressure cleaning equipment, as this will endanger its
proper working function.
Remove the drain hose
from this clamp to drain
the water.
Draining of Dirty water tank
When work is completed, the dirty water tank has to
be drained and rinsed.
Ÿ The hose used to drain the dirty water.
Draining of Fresh water tank
The tank requires rinsing at regular intervals.
Ÿ The water level hose is used to drain the fresh water.
Procedure for draining tanks
Ÿ Unclamp the drain hose from the hose clamp.
Ÿ Lower the tip of the drain hose to the floor level
Ÿ After draining the water completely, clamp the hose in
the hose clamp.
After lowering the brush move the machine
immediately; otherwise the brush might leave
traces on the floor. Lift the squeegee during reverse
travel. When passing over dormers with a height of
more than 0.7° in =10 mm, the brush drive must be
turned off and the brush must be lifted up.
Ÿ Cleaning of floor areas starts from the wall corner and is
effected stripe by stripe.
Ÿ In case of unoccupied areas it will be useful to clean at
first the border areas, passing with the machine along
those areas in counterclockwise sense.
Ÿ Cleaning of the remaining areas then should be effected
stripe by stripe, starting from the outlet socket.
Ÿ Check the strainer upstream of the intake opening in the
fresh water tank; clean if required, as otherwise the
suction efficiency will be affected.
To Next Page
Loading...
