Ropex RESISTRON RES-408 User Manual

Controller functions
Version 1 RES-408 Page 45
The various hold modes are shown below:
The "HOLD" LED on the terminal lights up if a temperature value is indicated in hold mode.
11.12 Temperature unit Celsius / Fahrenheit (as of controller SW revision 106 and ter-
minal SW revision 103)
As of controller software revision 106 AND terminal software revision 103 the unit for the temperature indication
and value selection can be switched between °C (Celsius) and °F (Fahrenheit). The unit is switched by pressing
ACTUAL
temperature
START
signal
24VDC
T
t
t
0
0
Hold OFF
T
t
0
ACTUAL indication
Hold On
T
t
0
Hold On2
T
t
0
Hold Hold
Hold Hold
End of
Heatsealing phase
2 s 2 s

Ropex RESISTRON RES-408 Specifications

General

Brand	Ropex
Model	RESISTRON RES-408
Category	Controller
Language	English