CASE 6A series
User Manual
11
© 2004-2006 Rosewill Inc. All rights reserved by Rosewill
8.USB Port
PIN ARRANGEMENT OF YOUR UNIVERSAL USB 2.0 CABLE
The USB 2.0 is compatible ackwards USB 1.1
1. Befor connecting your USB 2.0 cable please make sure that your motherboard is offering USB 2.0 interface. The easiest way to
check this is to look into your motherboard manual under the detailed descriptions of the various interfaces. Most frequently there
will be a picture of the pins with which the cable is attached. The number of pins on your motherboard might not always equal the
number of connectors on the USB cable. This does ot affect installation.
2. Each pin is defined very strictly. Please pay attention to the figures below, which help install the USB cable fast, safely and easily.
Any installation mistake may cause severe damage to your motherboard and other components.
3. The USB 2.0 connector design is to prevent installation error. Please connect the USB 2.0 port & M/B USB pin.
See the figures as belos.
To Next Page
Loading...
