Rossi Model 92 Disassembly
select an image for a larger view
Screw Nomenclature and Location
Click Here for an exploded view of the Rossi 92
1. Unscrew the tang screw and
remove the butt stock.
2. Pull back the hammer until the
small hole in the main spring rod is
visible in the 'V' of the main spring
rod block. Insert a small nail or pin
into the hole to keep the main
spring from flying off.
3. Remove the bolt pin stop screw.
4. Drive out the bolt pin from the
right side using small punch. It only
comes out right to left. and it only
goes back in the reverse order
http://www.leverguns.com/articles/taylor/field_strip.htm
To Next Page
Need help?
General
