Rosslare AC-C32 - Programming the Ac-C31; Entering Programming Mode; Exiting Programming Mode

Programming the AC-C32
Programming the AC-C32 is done solely via the unit's keypad driven
Programming Menu System. To reach the Programming Menu
System the AC-C32 must first be placed into Programming Mode.
See "Entering Programming Mode" on Page 17 for more
information.
During the AC-C32's manufacturing process certain codes and
settings are pre-programmed. These settings are the called the
"Default Factory Settings".
The table below shows the names of all the AC-C32 Menus. It also
shows of all the AY-C32's default factory codes and settings.
2580 Change Open Code 1 1
0852 Change Open Code 2 2
1234 Change Program Code 3
3838 Change Normal / Secure Code 4
N/A Change Normal / Bypass Code 5
0004 Change Door Release Time 6
Enroll Proximity Cards, PIN Code or both. 7
Delete Proximity Cards Or PIN Code 8
Return to Default Factory Setting 0
You will find a complete description and instructions for each of the
above menu items on the following pages.
Programming Menu
Page 16
06/01
AC-C32
Page 17
06/01
Entering Programming Mode
Exiting Programming Mode
1) "#"
2)
Note:
1)
"#"
2)
3)
4) "#"
Press the key for 2 seconds.
Mode LED will turn off
Door LED will turn red
Enter your 4-digit Programming
Code.
If the Programming Code
is valid the door LED will turn
green and the AC-C32 will be in
Programming Mode.
- The AC-C32 must be in Normal Mode to enter the
Programming Mode.
- The factory default Programming Code is 1234
- If a Programming Code is not entered within 5 seconds,
the AC-C32 will return to Normal Mode.
To exit the Programming Mode at any time:
Press the key for 2 seconds.
You will hear 3 beeps.
The Door LED will be off
The Mode LED will turn green
This indicates that the AC-C32 has returned to Normal Mode.
Wrong entries may reset the controller back to Normal Mode.
While in Programming Mode if no key is pressed for 1 minute the
AC-C32 will exit programming mode and return to Normal Mode.
A short press on key may also return the system to Normal
Mode in certain Programming Modes.
!
!
!
!
!
AC-C32
Mode Door
Mode Door
GREEN
RED
12
3
4
Mode Door
GREEN
Menu Description
Factory
Settings
Menu
Number