Roswell R6 - Speaker Mounting to Tower; Attaching Clamp to Speaker; Securing Clamp on Tower; Final Audio and Power Hookup

Loop the safety lanyard over the tower next to the
speaker clamp.
3/16”
THREADLOCKER
Q
R
Rev. 08-Mar-11
Pg. 5/6
R6 Hanging Speaker
Installation Instructions
If you have any questions please call : 1-780-962-0868
S
Insert the internal rotational disk at the desired angle
inside the clamp. The internal disk will rotate through
each position for perfect alignment.
Place the clamp on the speaker neck, apply RED
Loctite to 3 clamp bolts and fasten clamp to speaker.
T
Select the appropriate clamp inserts* for your tower,
for the 2 3/8” clamp inserts use the shorter set screws.
Apply RED Loctite to the two clamp bolts and set screw.
Holding the speaker in the desired position, place the clamp
around the tower tubing and close. Replace hardware and
tighten.
U
V
Note - To ensure tight fit use the correct plastic clamp inserts
and set screws.
*You will have two sets of clamp inserts and two set screws
remaining after installation. Keep for future use or recycle.
5/16”
x2
x2
With your stereo/amp switched off, 1) plug the RCA
jacks into the speakers, 2) then insert the male
speakon into the female on the deck, and twist
clockwise to engage.
THREADLOCKER
Rotational Disc
x6
2 3/8”1.9”
2)1)
TOWER