Need help?Do you have a question about the Roswell RMA 600.4 and is the answer not in the manual?
Provides general installation guidance, safety warnings, and advice on amplifier placement.
Explains the importance of adequate power supply and a healthy charging system for amplifier operation.
Details proper grounding techniques and best practices for running power and signal cables.
Explains input sensitivity, protection indicators, and accessing the amplifier's control panel.
Introduces the concept of crossover filters and their role in managing audio frequencies.
Explains the operation of High-Pass (HPF) and Low-Pass (LPF) filters and their frequency response curves.
Details Bandpass (BP), Subsonic filters, and the 'Full' range setting for audio output.
Describes the 'Double' setting for the 600.4 amplifier, used for bridged mode.
Covers the Bass Boost feature and the use of the remote gain control module for amplifier adjustment.
Explains RCA line outputs for linking amplifiers and the connection method for speaker outputs.
Provides a numbered sequence of steps for wiring and connecting the amplifier.
Lists the specific fuse ratings recommended for each amplifier model.
Illustrates the power input and connection points for the RMA 600.1 amplifier.
Shows typical wiring configurations for the RMA 600.1 with subwoofers.
Illustrates the power input and connection points for the RMA 500.2 amplifier.
Details the specific controls available on the RMA 500.2 amplifier.
Shows wiring configurations for 2-channel and bridged mono outputs of the RMA 500.2.
Explains the crossover (LPF/HPF) and Level settings for the RMA 500.2.
Illustrates power inputs and wiring for 4-channel and 3-channel configurations of the RMA 600.4.
Details the 2-channel mode and RCA input connections for the RMA 600.4.
Explains the various control settings available on the RMA 600.4 amplifier.
Illustrates power inputs and the 5-channel mode wiring for the RMA 800.5.
Shows how to connect RCA inputs for different modes of the RMA 800.5.
Details wiring for 3-channel bridged and 4-channel modes of the RMA 800.5.
Explains the 2-channel mode and RCA input connections for the RMA 800.5.
Shows the wiring diagram for 2-channel bridged outputs of the RMA 800.5.
Details the control panel settings for the RMA 800.5 amplifier.
Lists power output, frequency response, and sensitivity for RMA 600.1 and 500.2 models.
Lists power output, frequency response, and sensitivity for RMA 600.4 and 800.5 models.
Warns about amplifier heat during operation and provides optimal mounting recommendations for cooling.
Advises on the risks of prolonged exposure to high sound pressure levels and hearing damage.
Outlines the terms, conditions, and process for warranty claims and service.
General| Channels | 4 |
|---|---|
| Power Output (RMS) | 600W |
| RMS Power @ 4 Ohms | 75W x 4 |
| THD @ 4 Ohms | <0.05% |
| Signal-to-Noise Ratio | >90dB |
| Input Sensitivity | 200mV - 6V |
| Bass Boost | 0dB / +6dB / +12dB @ 45Hz |
| Dimensions | 12.6" x 2" |
| Impedance | 2 Ohms |
To Next Page
