Rotel RB-1070 Technical Manual

Technical
Manual
STEREO POWER AMPLIFIER
RB-1070
Table of Contents
Specification
Specification......................................1
Parts List ...........................................2
Adjustment........................................3
Case Outlines....................................3
PCB Assembly ..................................3~4
Schematic Diagram ..........................5~6
Continuous Power Output Stereo Mode 130 watts/ch into 8 ohms
(20 - 20 kHz, <0.03% THD)
Bridged Mono Power Output 300 watts/ch into 4 ohms
(20 - 20 kHz, <0.1% THD)
Total Harmonic Distortion <0.03 %
(20 Hz : 20 kHz, 8 ohms)
Intermodulation Distortion <0.03 %
(60 Hz : 7 kHz, 4 : 1)
Frequency Response (+0.5 db, -3 db) 4 Hz - 100 kHz
Damping Factor (20-20,000 Hz, 8 ohms) 500
Speaker Impedance (combined load) 4 ohms minimum
Signal to Noise Ratio (IHF A network) 120 dB
Input Impedance/Sensitivity 33 k ohms/1.0 volt
Power Requirements USA: 115 volts, 60 Hz
Europe: 230 volts, 50 Hz
Power Consumption 400 Watts
Dimensions (W x H x D) 430 x 121 x 350 mm
1615/16 x 43/4 x 133/4 in
Weight (net) 11.9 kg/26.25 lb.
SHINSEN-BLD. 4F 10-10 SHINSEN-CHO, SHIBUYA-KU,
TOKYO 150-0045, JAPAN
Serial. NO.
Beginning
®
Quality Uncompromised
Y-323A-00015C/S-S

Rotel RB-1070 Specifications

General

Damping factor	500
Amplifier class	-
Frequency range	4 - 100000 Hz
Input sensitivity	1000 mV
Audio output channels	- channels
Peak power per channel	130 W
Signal-to-Noise Ratio (SNR)	120 dB
Total Harmonic Distortion (THD)	0.03 %
Power consumption (typical)	400 W
Product color	Black, Silver

Weight and Dimensions

Depth	334 mm
Width	433 mm
Height	121 mm
Weight	10200 g