Need help?Do you have a question about the Roto-Jet 2200 and is the answer not in the manual?
General| Brand | Roto-Jet |
|---|---|
| Model | 2200 |
| Category | Water Pump |
| Language | English |
Explains the pump's basic working parts and operation.
Explains how Roto-Jet pumps are designated by model and serial numbers.
Lists recommended tools and assembly stands for disassembly and assembly.
Provides dimensional data for the 2200 2x2 pump model.
Provides dimensional data for the 2200 3x2 threaded pump model.
Provides dimensional data for the 2200 3x2 flanged pump model.
Presents a sectional view and torque table for the 2x2 pump.
Presents a sectional view and torque table for the 3x2 pump.
Lists various components and their part numbers for the 2200 pump.
Lists components for the rotor assembly.
Details mechanical seals and their associated parts for the 2-7/8" Type S seal.
Lists parts for the 3-1/2" Type SD single/double seal.
Provides a shimming diagram and chart for the 2-7/8" Type S single seal.
Provides a shimming diagram and chart for the 3-1/2" Type SD seal.
Lists steps to prepare the pump for disassembly, including lockout and draining.
Provides precautions for safe and satisfactory pump disassembly and assembly.
Step-by-step instructions for removing the 2-7/8" Type S single mechanical seal.
Step-by-step instructions for removing the 3-1/2" Type SD single/double mechanical seal.
Detailed steps for removing the rotor assembly from the pump.
Steps for removing the rotor cover and pick-up tube.
Detailed steps for removing pump bearings from the shaft.
Instructions for removing the pedestal sleeve from the pedestal bore.
Detailed steps for installing pump bearings onto the shaft.
Instructions for installing the rotor cover onto the rotor.
Steps for installing the rotor assembly into the pedestal.
Specific steps for installing the 2-7/8" Type S single mechanical seal.
Specific steps for installing the 3-1/2" Type SD single/double mechanical seal.
Instructions for replacing the seal hub on 3-1/2" seals.
Instructions for installing the pick-up tube and manifold.
Steps to remove the rotor from the driveshaft.
Steps to install the rotor onto the driveshaft.
Procedures for balancing the rotor assembly.
Lists minimum recommended spare parts with part numbers.
Lists auxiliary equipment, specifically bypass orifices and their part numbers.
General information on ordering parts, subject to change.
Instructions for placing orders with required information.
Procedures for converting the rotor assembly drive type.
Illustrates alignment tool locations for the 2x2 pump model.
To Next Page