Roto 85 FS - Ignition; Ignition Installation; Ignition Power Supply

ROTOmotor Ltd., Czech Republic - Europe
ROTO 85 FS
ROTOmotor Ltd., Czech Republic - Europe
Operating instructions
ROTOmotor manufacturer of top four-stroke engines
Page:10
Ignition
5.1 Ignition installation
Never remove the Hall sensors from the backplate.
5.2 Ignition power supply
The recommended power supply for ignition is 4-9V.
Always charge the batteries before ying.
Do not rely on charging from the last ight!
Ignition installation is an integral part of installing an engine in an aircraft.
Place the ignition in a suitable place where there is no risk of excessive heat from the
cylinder heads or the exhaust system.
If the ignition is heated above 60 °C, the ignition will switched off and the engine stops
working.
Make sure that the ignition is
well and suciently cooled!
Make sure that the connectors are
tted correctly and that there is no
risk of loosening them!
Do not bend the HV cables into sharp
bends, they may be interrupted!
Install the spark plug cup from the ignition to the spark plugs.
5.