ROTORCOMP VERDICHTER Operating Manual - EVO
®
Line
1.2 [en] 07/2020
1.5.2 Purpose
The screw compressor air ends are oil-injected
screw compressor air ends that form a perfectly
matched compressor unit when completed with
components from the ROTORCOMP product
range.
The sole intended use of the system is the com-
pression of atmospheric air. The screw compres-
sor air ends may only be used to compress gases
or other media following written approval by
ROTORCOMP.
The installation of the screw compressor air ends
or the assembly of these with components to form
a compressor unit may only be carried out by spe-
cialized companies with the corresponding know-
how.
The safety precautions, technical data, limits,
installation guidelines and regulations for commis-
sioning and operation specified in this operating
manual must be observed and complied with.
1.5.3 Delivery scope
ROTORCOMP supplies screw compressor air
ends in accordance with the order confirmation.
1.5.4 Optional components
ROTORCOMP offers matching components for all
screw compressor air ends for system construc-
tion. As a result, there are also matching compo-
nents for an extremely broad range of applications
and operating modes. The "Screw Compressor
Technology" catalog from ROTORCOMP is avail-
able to help you choose the right screw compres-
sor air ends and components.
Optionally available components are marked with
(optional).
1.6 Warranty information,
liability disclaimer
ROTORCOMP is a manufacturer of screw com-
pressor components and not of ready-to-operate
compressor systems.
RC shall only be answerable for any defects of
these individual components for which it is respon-
sible within the scope of the warranty conditions.
Failure to comply with the following instructions
and information shall void any and all liability. This
liability disclaimer also results in the loss of claims
for damages. This applies in particular in case of:
– Incorrect installation
– Improper use
– Operation of the screw compressor air ends
outside the specified limits (see chapter 9.1
Technical data)
– Failure to observe the safety precautions and
the usual care and caution
– Unsuitable operating materials (gases, oils)
– Formation of condensed water in the screw
compressor air ends
– Corrosion as subsequent damage
– Improper operation
– Insufficient maintenance, missing proof of
maintenance
– Use of unsuitable tools
– Failure to use genuine spare parts
– Unauthorized modifications to the screw com-
pressor module and/or its components
1.7 Nameplates
For the location of the nameplate, see Figure 3-1
to 3-3.
Should you have questions, please provide us
with the data on the nameplate. This ensures that
you receive the correct information.
Figure 1-1
Stamping for customers outside Germany
(Europe)
1. Serial No.
2. Version No.
3. Model
4. Max. operating temperature
5. Max. operating pressure
1
2
3
4
5
To Next Page
Loading...