RotorWay Exec 162 - Page 9

RotorWay International
Exec 162F Construction Manual
Section 1
Page 7
Photo #4
Use a large drill bit to countersink the 1/8" pop rivet
holes.
Photo #5
Use a hand drill and a 3/8" bit to open the Dzus
button hole. Then install the spring wire with pop
rivets.
Photo #6
Use a hand drill and a 3/8" bit to open the hole for
the grommet. Install the grommet with the large
end on the same side that the head of the button
will be on. Place it on a hard surface with the
pointed end of the tool toward the grommet.
Hammer to expand the small end.