23
INITIAL START UP PROCEDURE
After first filling your spa, dose either Rotospa Granular Shock or Rotospa Non-Chlorine Shock while
the pump (only) is running and this procedure ensures that any water remaining in the spa (from
factory testing) is immediately treated and bacteria free. Begin bathing only when you have followed
the guidance below and chlorine or bromine levels fall back to the normal range.
THE IMPORTANCE OF CIRCULATION & FILTRATION
Your spa will include a pump and a filter chamber as standard, and some models will include a blower.
It is a combination of circulating the water through the cartridge, to collect suspended particles and
grease, together with good chemical water treatment, that helps you maintain clear, clean and
healthy water.
It is advised to run your spa’s circulation every day. Whilst your spa is factory-programmed to run a
filtration cycle at regular intervals throughout the day, it is worth noting that if the filter cartridge is
dirty, filter efficiency and circulation are impaired often leading to poor water quality. Typically,
cartridges need deep cleaning every 4-6 weeks, but more regularly when usage or contamination is
high.
WATER TESTING AND IDEAL CHEMICAL LEVELS
A Guide to Testing your water
We recommend that you use our Lovibond Pool Tester. This unit tests both the pH levels and the
sanitiser levels (Bromine or Chlorine). These are far more accurate than using test strips and are very
easy to use. Please see the diagram on the following page for how to use the test kit.
Depending on your usage of the spa, water testing procedures will vary. Domestic users are advised
to follow the guidelines on the next page of this guide.
In commercial installations, HSE guidelines regarding spa water testing must be adhered to.
Taking care of your Water
To Next Page
Loading...
