Rowenta DW7180 User Manual

11
* depending on model
Brown streaks come
through the holes
inthe soleplate and
stain the linen.
None or too little
steam is being
emitted.
Residues in the steam
chamber or on the
soleplate.
Use the Anti Calc function then clean
your iron.
Anti-Drip is active (§ 9). Wait for the soleplate to reach the
correct temperature.
Not enough water in the
water tank.
Fill the water tank.
Steam control set on dry
position .
Turn the steam control to the required
setting area.
Use of chemical descaling
agents.
Do not add any descaling agents to the
water in the water tank. Use the Anti
Calc function and clean your iron.
Fabric fibres have
accumulated in the holes
of the soleplate and are
burning.
Clean the soleplate with a non-metallic
sponge.
Vacuum the holes of the soleplate from
time to time.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
Ensure linen is rinsed thoroughly to
remove any soap deposits or chemicals
on new garments which may be sucked
by the iron.
Use of starch.
Always spray starch onto the reverse
side of the fabric to be ironed and clean
your iron soleplate.
Pure distilled /
demineralised or softened
water is being used.
Only use untreated tap water or mix
half tap water with half distilled/
demineralised water. Use the Anti Calc
function and clean your iron.
Iron is leaking.
Overuse of burst of steam
button.
Soleplate temperature too
low .
Set the temperature control to a higher
temperature.
Allow more time between each burst.
PROBLEMS?
Problems Cause Solution
The iron is plugged
in, but the soleplate
of the iron remains
cold.
No mains supply. Check that the mains plug is properly
inserted or try plugging the iron into a
different socket.
Temperature control set
too low.
Set the temperature control to a higher
temperature.
The automatic electronic
Auto-Off* is active.
Move your iron.

Rowenta DW7180 Specifications

General

Brand	Rowenta
Model	DW7180
Category	Iron
Language	English