10
control into the Anti Calc position (fig.5) : steam will now begin to build up. After a few
seconds water will emerge from the soleplate, rinsing dirt and scale particles out of the
steam chamber.
Move the steam control to position after approx. 1 minute.
Plug in the iron and allow the iron to heat up again. Wait until the remaining water has
evaporated. Unplug from the mains and allow the iron to fully cool down.
When cool, the soleplate can be wiped with a damp cloth.
TIP Use the Anti Calc function approx. every 2 weeks.
If the water is very hard, clean the iron weekly.
16 • Cleaning the iron
When the appliance has cooled down, wipe it down with a damp cloth or sponge, as
required.
Remove the dirt from the soleplate with a damp cloth or sponge.
IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean
soleplate and other parts of the iron.
If the appliance has been standing unused for long periods, use the Anti Calc
function (see § 15).
* depending on model
To Next Page
Loading...
Need help?
General