• Remove the water tank by pushing it back and away from appliance.
• Unplug the rubber stopper.
• Fill the watertank to the top with water and close it securly. Make sure
that the rubber stopper is properly pushed in place - as shown below.
• Put the tank onto the handle until it snaps in.
• Completely unwind the power cord.
• Plug in your steambrush.
Important: Heat concentrates the elements contained in water
during evaporation. The types of water listed below may contain
organic waste, mineral or chemical elements that can cause
spitting, brown staining, or premature wear of the appliance:
water from clothes dryers, scented or softened water, water
from refrigerators, batteries, air conditioners, rain water, boiled,
filtered or bottled water. Also use distilled or demineralised
water only as advised above.
Warning ! Never use 100%, distilled or demineralised water as this
can cause the appliance to spit and leak.
To Next Page
Loading...
Need help?
General
