Use
• Once the appliance is plugged in, the light will
turn on. Set the steam control dial to the desired
setting.
• After approximately 30 seconds, the light will
turn off indicating the steambrush has reached
working temperature.
Steam setting
Set the steam output to the type of fabric to be ironed - see table below.
Type of fabric
Setting
steam
Cotton / Linen
Silk / Wool
Synthetics
During use or while unit is heating or cooling, do not rest appliance
on its head. Place product on its side on a firm, heat resistant, flat
surface, as the head will be hot. As the appliance heats, the housing
becomes warm. This is normal.
Be sure to remove lint pad when steaming as excessive water or
steam can cause lint pad color to run.
• To begin steaming, press the steam button with
the steamer head facing away from you, in a
vertical position.
To Next Page
Loading...
