Threads, lint and hair can easily be removed with the lint pad by brushing
the fabric slowly from left to right.
The pad can be cleaned by brushing in the opposite direction right to left
on a scrap of old cloth.
Lint pad
• Remove the lint pad from the steambrush by
grasping on both sides and pulling downwards.
The lint pad should slide right off of the brush,
and clamp back on after use.
• For storage, attach the lint pad to the steam
brush by lining up the slots of the brush with
the slots of the lint pad. Gently push the top of
the lint pad into place until it snaps in.
Warning: Never touch the steam head until it is completely cool.
Warning: never forget to unplug your device and empty the tank after
each use. While not in use, you can hang the steambrush by its hook.
•Gently press the fabric brush against the
clothing and move the steambrush down the
fabric. Keep pressing the burst of steam button.
• The combination of steam and fabric brush will
gently remove the wrinkles.
• After treatment, let the garment cool down on
the hanger before wearing.
After use
• Unplug the appliance. Empty the water remaining in the tank and leave
unit on its side to cool. After the appliance has cooled down, it may be
stored in the bag provided (depending on model).
Do not allow steambrush to run dry.
The lint pad must not be used when attached to appliance.
To Next Page
Loading...
Need help?
General
