Rowin TWIN LOOPER User Manual

1
/
7
TWIN LOOPER manual
Thanks for purchasing our product, please read the operating instructions below carefully before
operate.
1. Right footswitch
1) Right foot switch functions need to use with mode selection switch: FX / STOP
2) When the mode selection switch select STOP mode, right footswitch is used to stop
recording and playback, or clear recording data, Using with LOOPER indicator LED, this
operation can not be restored.
3) When recording (LOOPER indicator LED is red) or playing (LOOPER indicator LED is green),
press right footswitch once, recording or playing will immediately stop, LOOPER indicator LED is
green and flashing.
4) If stopped (LOOPER indicator LED is green and flashing), press right footswitch about 2
seconds, LOOPER indicator LED flashes twice, then all of the recorded data is cleared.

Rowin TWIN LOOPER Specifications

General

Number of Loops	2
Input Impedance	1M Ohm
Power Supply	9V DC (center negative)
Frequency Response	20Hz-20kHz
Weight	300g
Type	Looper Pedal
Current Consumption	100mA
Output Impedance	100 Ohms

Summary

Right Footswitch Control

STOP Mode Functions

Manages stop, playback, and clearing operations when the mode selection switch is set to STOP.

FX Mode Functions

Manages effect on/off operations when the mode selection switch is set to FX.

Left Footswitch Operations

Recording and Playback Cycle

Controls recording, playback, and overdub states with the left footswitch.

Undo/Redo Functionality

Manages undo and redo operations for recorded data using the left footswitch.

Stop and Clear Loop

Handles stopping the loop and clearing all recorded data.

Indicator LEDs

FX LED Status

Indicates the status of the effect (on/off, color coding for playing direction).

LOOPER LED Status

Shows the state of the looper (recording, playing, overdub, stop, undo/redo completion).

Input and Output Jacks

Right Input/Output

Connects the guitar to the right input and amplifier to the right output.

Left Input/Output

Connects the guitar to the left input and amplifier to the left output.

Mode Selection Switches

FX/STOP Mode Selection

Selects between FX mode (effect on/off) and STOP mode (operation control).

Channel Mode Selection

Determines output channel routing (normal or swapped left/right channels).

Speed and Volume Controls

Recording/Playing Speed Knob

Adjusts recording and playing speed across 11 gears (normal, fast, slow).

Output Volume Knobs

Controls the volume for the left and right output channels.

Power and USB Interface

Power Requirements

Specifies the 9V DC power requirement and current draw.

USB Connectivity and Firmware Update

Enables computer connection for firmware updates and file transfer.