To Next PageTo Next PageWhat to do if Royal Sovereign ARP-1008 does not run and water full indicator is lit?
If your Royal Sovereign Air Conditioner isn't running and the 'water full' indicator is illuminated, it probably means there's too much water in the unit. You should drain the excess water.
Why Royal Sovereign ARP-1008 runs but does not cool?
If your Royal Sovereign Air Conditioner is running but not cooling, there might be several reasons. First, check for open doors or windows and close them. Another appliance in the room could be generating heat; identify and turn it off. A dirty air filter can also cause this issue, so inspect and clean it if needed. Ensure that the air exhaust or intake isn't blocked. Finally, the set temperature might be too high; lower it as necessary.
What to do if Royal Sovereign ARP-1008 does not operate?
If your Royal Sovereign Air Conditioner isn't operating, start by checking and resetting the power plug. Wait 3 minutes before attempting to restart the unit. Ensure the plug is properly inserted into the outlet. Also, the remote's batteries might be depleted, so replace them. The set temperature might be too close to the room temperature, so try lowering it. Finally, make sure the air outlet isn't blocked by any obstructions.
General| Brand | Royal Sovereign |
|---|---|
| Model | ARP-1008 |
| Category | Air Conditioner |
| Language | English |
Details essential electrical requirements and safe power cord usage for the unit.
Provides guidelines for safe and proper everyday operation of the air conditioner.
Instructions for attaching the exhaust hose connector to the exhaust hose.
Steps for attaching the hose fixture to the window slider kit.
Guide on how to properly install the window slider kit in the window.
Procedure for connecting the exhaust hose to the portable air conditioner unit.
Steps for connecting the exhaust hose to the installed window slider kit.
Procedure to ensure the power plug's circuit breaker is functioning correctly before use.
Overview of buttons and their functions on the remote control for operating the unit.
