................................................................................
Change the ROWASHER Microbe Filter Mat EVERY MONTH
To Maintain Cleaning Performance
For Technical Support or to order more consumables
Tel: +44 (0)121 526 8181 www.rozone.co.uk
6. SETTING UP
After removing packaging, check the unit for transport
damage. If any defect is detected do not connect the
machine to the mains. Report damage to vendor.
Situate the ROwasher on flat stable ground. The floor
must be even to ensure safe operation.
Press the wheel brakes on the rear of the machine
Remove the black sink tray
Unpack the ROwash Microbe Filter Mat and place it
white side up on top of the filter support grid
Replace the black sink tray on top
Pour 80 litres of ROwash Cleaning Solution slowly into the sink
Do not overfill
WARNING – Adding any other cleaning solution or liquids such as solvents,
disinfectants and alkaline cleaners can deactivate the microbes and the bio-
remediation of grease and oil will be affected resulting in the ROwasher not working
properly.
Plug into the correct mains supply. To avoid damage, the machine must be plugged
into the power source stated on the machine control box label. Switch on electrical
supply
The ROwasher will begin to heat up the cleaning solution to its optimal working
temperature of 42°c. (This will take approx. 4 hours)
To Next Page
Loading...