T1 Universal System Controller
8
DOCKING STATION REFERENCE
1-3/8 in.
(35mm)
Power Jack
Wire Guide
Wall Mount
Holes
Back
Charge LED
Charge Contacts
Front
Introduction
5
BATTERY AND DOCKING STATION
The T1 uses a Lithium-Ion rechargeable battery. This battery does
not exhibit any type of “Memory Effect” from being charged too
often. Since the T1 can safely be charged after each use, a docking
station is included for convenience. If left out of the docking
station, the T1 will remain in sleep mode for 1 – 2 months before
shutting down. At that point the battery must be recharged.
If the T1 battery capacity is reduced to approximately one hour of
remaining run-time, the Status LED will illuminate red while the
unit is powered-up.
The T1 Docking Station can be placed on a flat surface such as a
shelf or table, or it can be mounted to a wall using the mounting
holes on the back of the unit.
The docking station LED illuminates to indicate a charge in
progress. The LED will turn off when the battery in the unit is
fully charged.
A fully discharged battery will take approximately 2-4 hours to
completely re-charge.
The T1 can remain in the docking station indefinitely without
damage to the battery.
GETTING STARTED
Start by inserting the battery connector into the mating plug on
the T1. Make sure the connector is oriented properly before
attempting to insert it.
To Next Page
Loading...
Need help?
General
