RTI T2i - Screen Calibration T2 i; Change WiFi Settings; Reset Battery Memory; Touchpanel Operations

3 | P a g e
08/2020
Tips for Touchscreen
Remotes & Touchpanels
F. Access the Screen Calibration of a T2i Remote Control
On the Control Panel page press the following button sequence.
1. Guide
2. Menu
3. Guide
4. Menu
5. Channel Up
Tap the touch screen to leave the calibration mode.
G. Change WiFi Settings of T2i, T2x, T3x, T4x Remote Controls
When making any changes to the WiFi settings of a remote, you need to power cycle the remote after
uploading your file in order to apply the new WiFi parameters to the remote’s systems.
H. Reset the Battery Memory of T2i, T2x, T3x, T4x Remote Controls
T2i, T2x, T3x, T4x battery memory can be reset as follow:
1. Flash the firmware
2. Remove & replace the battery
3. Charge for 24 hours
I. Access the Screen Calibration Mode of a KX2 Touchpanel
Access the KX2 control panel by holding down the button located in the
lower right corner of the KX2 (default labelled with the power symbol),
while applying power or resetting the KX2. Then press the following
button sequence:
1. Top Left Button
2. Bottom Right Button
3. Top Left Button
4. Bottom Right Button
5. Top Right Button