RTW PortaMonitor - Page 51

PortaMonitor Switches and menus  Page 7-9
7.7.8. Submenu: LOUDNESS
DISPLAY Loudnessdisplay ON/OFF
COLOR Color for Loudnessdisplay
7.7.9. Submenu: DIGITAL-ERRORS
WORD-WIDTH Word width for analysis from MSB: 16 - 24 Bit
OVER-SAMPLES Number of consecutive samples with a value
defined by -SENS for over-display: 1 - 15 samples
-SENS Threshold for overload detector sense: FSCALE,
FS-1 LSB, FS-2 LSB, -0.1 dB, -0.5 dB, -1.0 dB,
-2.0 dB, -3.0 dB
MUTE-CHECK MUTE- check condition (digital zero) OFF/TIME/
SAMPLE
-TIME Sequence length for digital zeros before activating
MUTE display: 50 ms, 100 ms, 200 ms, 300 ms
-SAMPLES Number of consecutive samples with a value zero
before activating MUTE display: 5 to 80 samples in
steps of 5 samples
INDICATION Hold time for digital error display: 1.0 s or
MANUAL (permanent display until manual reset).
7.7.10. Submenu: NUMERIC
DISPLAY Operation mode for numerical display:
OFF
MEM/RESET - Display by the use of the MEMO-
key, clear by the use of the RESET-key
CONTINUE - continous display
HOLD-TIME MAXIMUM - max value since reset
FAST, 2.5s, 10.0s (autoreset)
DIGITS DIGITAL Selection of resolution for numerical display
Digital mode: 1 = 1/10 dB , 2 = 1/100 dB
Analog mode: allways 1/10 dB
FIELD 1-4 Means for numeric field 1 to 4:
OFF - no display
LEVEL - level display
FIELD 5-8 OFF - no display
OVER-COUNT - display overload counter
COLOR Color for numerical display
7.7.11. Submenu: RTA
MODE [A/P] Detector mode: AVG/PEAK
RESPONSE [TC] Detector integration: FAST/MEDIUM/SLOW
PEAKHOLD Peakhold display mode and reset time
OFF, 2.5 s, 4.0 s, MAN