Ruckus Wireless SmartCell Gateway 200 Reference Guide

MAP Authentication Messages
This section covers the following topics:
• MAP-SEND-AUTH-INFO Request on page 12
• MAP-SEND-AUTH-INFO Response on page 13
MAP-SEND-AUTH-INFO Request
This message is sent from the SCG to HLR for retrieving the authentication information.
HLR returns the authentication triplets as a response to this request. The below table
lists the MAP message attributes.
Table 6: MAP-SEND-AUTH-INFO request attributes
DescriptionTypePresenceAttribute
This attribute identifies corresponding
service primitives. The parameter is
supplied by the MAP service-user and
is unique for each
service-user/service-provider interface.
IntegerMInvoke ID
International Mobile Subscriber Identity
(IMSI) of the subscriber.
Maximum
15 digit
value
MIMSI
This parameter specifies the number
of minimum vectors required to
perform authentication for the client,
HLR may return more than requested.
For EAP-SIM user, it is set to 3 and for
EAP-AKA it is 1.
NOTE This parameter is applicable
for MAP version 3. The value of this
attribute will be sent only if the
EAP-SIM version is set to 3 while
configuring the HLR service profile in
the SCG Web interface.
IntegerCNumber of
Requested Vectors
Ruckus Wireless™ SmartCell Gateway™ 200 HLR Interface Reference Guide for SmartZone™ 3.5.1
12
MAP Messages
MAP Authentication Messages

Ruckus Wireless SmartCell Gateway 200 Specifications

General

Brand	Ruckus Wireless
Model	SmartCell Gateway 200
Category	Gateway
Language	English