Rugged CCTV Ruff Ride - IR;White Light Modes

24
Operation
GO TO 65
Increase the camera shutter speed
***
GO TO 66
Decrease the camera shutter speed
***
GO TO 67
Turn on cruise 2
***
GO TO 68
Turn on cruise 3
***
GO TO 69
Turn on cruise 4
***
GO TO 70
Turn on white lights only (only for white light models)
***
GO TO 71
Turn on white lights only (only for white light models)
√
GO TO 95
Enter menu
***
Table 2 Special Commands
Operation
As the baud rate and protocol are self-adaptive, the PTZ cameras may not response for seconds
on power up. It is recognizing the commands and adapting the setting.
IR / White Light
Auto Mode (For IR Version Only):
The default IR mode is auto. Auto mode can also be activated via preset 22. At this mode, the
commands of preset 30, 31 are disabled.
When the zoom module is in mono, the camera will automatically turn on IR lights. The high beam
and low beam will be turned on/off as per the current zoom times.
When the module is in color mode, the camera will automatically turn off IR lights.
Manual Mode:
Call Preset 21 to turn on the manual mode. The module will be switched into color or mono mode.
And lights can be controlled via the commands of presets 30, 31.
[Note] When the ambient temperature is above +50℃, the aux lighting system is suggested
to be turned off to protect the PTZ cameras.