What to do if no sound comes from Rugged Radios Two-Way Radio speaker?
If you're not getting any sound from your Rugged Radios Two-Way Radio speaker, there are a few potential causes: * The squelch might be muted. Try decreasing the squelch level. * Tone or CTCSS/DCS squelch could be active. Turn off CTCSS or DCS squelch. * Check if the 3.5mm external speaker jack is occupied.
What to do if PTT key is pressed but transmission does not occur on Rugged Radios Two-Way Radio?
If you press the PTT key on your Rugged Radios Two-Way Radio and no transmission occurs, consider these potential causes: 1. Poor microphone connection: Ensure the microphone is properly connected. 2. Poor antenna connection: Verify the antenna is correctly connected. 3. Poor Sound: Check the cable connection.
What to do if key and dial do not function on Rugged Radios Two-Way Radio?
If the key and dial on your Rugged Radios Two-Way Radio aren't working, it might be because the key-lock function is activated. Try canceling the key-lock function.
How to fix Rugged Radios Two-Way Radio if rotating dial will not change memory channel?
If the rotating dial on your Rugged Radios Two-Way Radio won't change the memory channel, it could be due to these reasons: * The transceiver is in CALL mode. Press the VFO or memory mode. * The radio is transmitting.
What to do if fuse is blown on Rugged Radios Two-Way Radio?
Check and solve problem resulting in blown fuse and replace fuse with new fuse.
Why nothing appears on Rugged Radios Two-Way Radio display when power is on?
If your Rugged Radios Two-Way Radio has power but nothing appears on the display, it's possible that the + and - polarities of the power connection are reversed. To fix this, connect the red lead to the plus terminal and the black lead to the minus terminal of the DC power supply.
What to do if there is no sound from my Rugged Radios GMR25 speaker?
If you're not getting any sound from your Rugged Radios Radio speaker, here are a couple of things to check: * Ensure the squelch isn't muted by decreasing the squelch level. * Verify that CTCSS or DCS squelch is turned off, if active.
What to do if the fuse is blown in my Rugged Radios Radio?
If the fuse in your Rugged Radios Radio has blown, identify and fix the problem that caused it to blow, and then replace the fuse with a new one.
How to unlock the keys and dial on my Rugged Radios Radio?
If the keys and dial on your Rugged Radios Radio aren't working, the key-lock function may be activated. Cancel the key-lock function to restore their functionality.
What to do if my Rugged Radios Radio power is on, but nothing appears on the display?
If your Rugged Radios Radio powers on but the display remains blank, check the power connection polarities. Ensure the red lead is connected to the plus terminal and the black lead to the minus terminal of the DC power supply.
General| Type | Handheld GMRS Radio |
|---|---|
| NOAA Weather Scan | Yes |
| Frequency Range | GMRS |
| Channels | 22 channels |
| Water Resistance | IP67 |
To Next Page
