3.5 Connecting Console
RG-WS6008 supplies an EIA/TIA-232 configuration console for local configuration. If you configure RG-WS6008 through
Web, skip this part.
Table 3-2 Console Attributes
57,600 bps, 115,200 bps, 9,600 bps (default)
Connect one end of the supplied configuration cable to the console port of the wireless controller, and the other end to the
DB-9 male serial adapter of the microcomputer.
3.6 Verification
When you have installed the wireless controller, before powering on it, pay attention to the following items:
If the wireless controller is stalled in a cabinet, check the mounting brackets of the cabinet and wireless controller are
firm. If the wireless controller is installed on the workbench, check there is enough room around the wireless
controller for heat dissipation and the workbench is firm.
Check the power supply meets the requirements.
Check the grounding cable is correctly connected.
Check the wireless controller is connected correctly to other devices such as the configuration terminal.
To Next Page
Loading...
Need help?
General