Note:
1. The device already in the WPS networking status will not be paired again if you
press the WPS button.
2. You can short press the LED/RESET button ❷ to turn off the LED.
Operating Status DescriptionLED Status
Scenario 3: Connect the Device to the Modem Directly
The device connects
to the network.
The system status LED
❹ is solid blue.
Please connect to the
configured Wi-Fi.
1.
The device is
starting up
after power-on.
2.
Startup is
complete.
Connect to the modem with an
Ethernet cable.
The system status
LED is blinking blue.
Please wait for 1 to 2 minutes.
The system status
LED is solid blue.
The system status LED is solid blue.
3.
4.
Power supply faceplate
ISP modem
Connect to the SSID @Ruijie-sXXXX broad-
casted by the Wi-Fi extender and perform
configuration. Please visit 10.44.77.254 by
browser to perform configuration if the configu-
ration page does not pop up.
The system status LED ❹
is solid red. The signal
status LED ❸ is solid white.
Please check whether the primary
router accesses the Internet.
The device
connects to the
primary router,
while the network
is unreachable.
To Next Page
Loading...
Need help?
General