Cookbook Configuration
65
Configuration of the branch router:
Check whether the routers in the HQ and branch can access each other.
Note
When the Internet access service is configured through wizard-based setup on the web of the router, IPsec
VPN can be configured only after the next-hop address is configured on the interface configuration page in
wizard-based setup. If no next-hop address is configured for an interface, the interface cannot be selected
during VPN configuration.
After VPN is configured, the router automatically delivers AAA configuration (the system asks you to enter
the user name and password during device login, and the telnet password needs to be reconfigured).
After deleting the VPN configuration, close the browser to make the deletion take effect. Otherwise, the
system retains the previous VPN configuration.
When a WAN port receives an IPsec request but no traffic is configured on the device, the error "Failed to
find map" may occur. This error is generated because packets from IPsec port 500 are sent to the CPU when
the IPsec map does not exist, and this does not affect network data forwarding and management. However,
To Next Page
Loading...
