Ruijie Reyee RG-NBR6215-E - Upgrade and Maintenance; Logging in; Logging in through the Web Management System

Cookbook Upgrade and Maintenance
129
4 Upgrade and Maintenance
4.1 Logging In
4.1.1 Logging In Through the Web Management System
The web management system provides a visualized graphical management interface, which is friendly, easy to
use, and can achieve efficient configuration and management.
Configuration Environment Requirements
The client (PC or mobile terminal) used for logging in to the web management system must meet the following
environmental requirements:
 Browser: Google Chrome, Internet Explorer 9.0, Internet Explorer 10.0, Internet Explorer 11.0, and some
Google/Internet Explorer kernel-based browsers, for example, 360 Security Browser (recommended mode:
Extreme) are supported. If you log in to the web management system using other browsers, exceptions such
as garbled characters or formatting errors may occur.
 Resolution: The recommended resolution specifications are 1024 x 768, 1280 x 1024, 1440 x 960, and 1600
x 900. If other resolutions are used, the fonts and formats may be out of alignment.
Key Points
There are two ways to access the web management system depending on the access interface:
 LAN access: Access the web management system through the default IP address of the router's LAN port.
In this case, the management PC must be on the same LAN as the router.
 WAN access: Access the web management system through the IP address of the router's WAN port. In this
situation, ensure that the device can access the Internet and the WAN IP is a public IP address.
Note
 Both LAN access and WAN access require connectivity between the management PC and the router
interfaces' IP address, that is, the management PC can ping the IP address of the router’s interface.
 If the router is configured for the first time, you are advised to access the web management system
through LAN access.
1. LAN access
Prerequisites
Table 4-1 lists the default web configuration of RG-NBR-E series routers. The router starts the web service by
default, and you can use the default value to log in to the web management system.
Table 4-1 Default web configurations
Item
Default Setting
Device IP address
(management IP address)
The default IP address of device LAN0 (Gi0/0) port is 192.168.1.1
After the router is configured initially or restores to factory defaults, the
default management IP address is 192.168.1.1.
If HTTPS is enabled, the initial management IP address is
192.168.1.1:4430.