5 Monitoring and Maintenance
5.1 Monitoring
LED
You can observe the LED to monitor the AP in operation.
CLI Commands
You can run related commands on the command line interface (CLI) on the AC to remotely monitor the configurations and
status of the AP.
You can log in to the AP via Telnet and use monitoring related commands to maintain the AP.
5.1.1 Remote Maintenance
If the AP operates as a Fat AP, you can log in to the AP remotely for maintenance.
If the AP operates as a Fit AP, you can use AC to centrally manage and maintain the AP.
5.1.2 Hardware Maintenance
If the hardware is faulty, please contact our Technical Assistance Center (TAC) for help.
To Next Page
Loading...
Need help?
General
