1-11
eWeb Configuration (Standalone Mode)
3 eWeb Configuration (Standalone Mode)
Functions are the same in different work modes. This chapter describes the Web configuration process of the switch in the
standalone mode as an example.
3.1 Home
The Home module displays the basic information about the device and the switch ports, as shown in the figure below:
Figure 3-1-1 Home
The Basic Info area allows you to configure the device name and the management IP address, and switch ’over the work
mode (described in the section Work Mode).
The Port Info area displays the details of all ports. Click Panel View to display the icon color and type corresponding to each
port status.
To Next Page
Loading...
