1-46
eWeb Configuration (Standalone Mode)
Click Batch Edit, select ports, and configure parameters. Alternatively, click Edit in the Action column, configure parameters,
and click OK.
1. Enabling the STP or changing the STP mode will initiate a new session. Do not refresh the page during the
configuration.
2. It is recommended to enable Port Fast on the port connected to a PC.
3.7.2 LLDP
The Link Layer Discovery Protocol (LLDP) is defined by IEEE 802.1AB. LLDP can discover devices and detect topology
changes. With LLDP, the eWeb management system can learn the topological connection status, for example, ports of the
device that are connected to other devices, port rates at both ends of a link, and duplex mode matching status. An administrator
can locate and troubleshoot faults quickly based on the preceding information.
Figure 3-7-3 LLDP Settings
LLDP settings
Enable LLDP, configure related parameters, and click Save.
To Next Page
Loading...
