Ruijie RG-NBS Series - Page 67

1-63
Configuration Guide
eWeb Configuration (Standalone Mode)
3.9.7 Reboot
The Reboot module provides the Reboot button, as shown in the figure below:
Figure 3-9-10 Reboot
 Reboot
Click Reboot, and click OK in the confirmation box. The device is rebooted and you need to log into the eWeb management
system again after the reboot. Do not refresh the page or close the browser during the reboot. After the device is successfully
rebooted and the eWeb service becomes available, you will be redirected to the login page of the eWeb management system.