Ruijie RG-WLAN Series - Page 16

Configuration Guide Configuring WLAN
Ruijie(config-ap)#eth-schd limit
Configure received Ethernet package limit per time on
the designated AP.
The limit value range of the following APs: 1-256
AP220-I v1.0, AP220-I v1.1, AP220-SI v1.0
AP220-SI v1.1, AP220-E v2.03, AP220-E v2.0
AP220-SH v2.0, AP220-SH (C) v3.0, AP220-E(M) v2.0,
AP220-E(M) v2.20, AP620-H(C) v2.0, AP220-E(C) v3.0,
AP220-E(M) v2.3, AP220-E v2.99, AP620-H(C) v2.99,
AP220-SH(C) v2.99
AP220-E(C) v2.99, AP530-I v1.0:
The limit value range of other APs: 1-200.
The default limit value of the following APs: 256
AP220-I v1.0, AP220-I v1.1, AP220-SI v1.0, AP220-SI
v1.1, AP220-E v2.03, AP220-E v2.0, AP220-SH v2.0,
AP220-SH (C) v3.0, AP220-E(M) v2.0, AP220-E(M)
v2.20, AP620-H(C) v2.0, AP220-E(C) v3.0, AP220-E(M)
v2.3, AP220-E v2.99, AP620-H(C) v2.99, AP220-SH(C)
v2.99, AP220-E(C) v2.99, AP530-I v1.0.
The default limit value of the following APs : 180
AP320-I v1.0, AP220-E(M)-V2 v3.0, AP320-I v1.1,
AP3220 v1.0, AP220-E(P) v1.0, AP220-E(C) v4.0,
AP220-E(M)-V2 v3.9.
The default limit value of the following APs: 64
AP330-I v1.1, AP220-E(P) v2.0.
The default limit value of other APs: 25
Configuring Low-Density Parity-Check Code
As part of FEC (Forward Error Correction) technology, LDPC is a simple and easily-implemented linear error correcting
code developed in the early 1960s that used in the data transmission over noisy channels to improve the coding reliablity
and coding gain,so as to reduce the risk of data loss. However, only few terminals are incomparible with LDPC, featuring
package loss. This commands is used to enable or disable this function.
Command Function